Fluoro-Plastics, Inc.  Fluoro-Plastics, Inc. 1-800-262-1910
customerservice@Fluoro-Plastics.com
PTFE Sheet PTFE Plate PTFE Rod PTFE Extruded Tube PTFE Thin Film Reinforced PTFE Bondable PTFE PTFE Guide Rails, Rectangular Bar & Wear Strips PTFE Custom Profiles PTFE Machined Parts Modified PTFE PTFE Teflon Square Bar Molded Cylinders Gaskets
Search Catalog
      GO   
 All Categories     Molded Cylinders
All Categories > Molded Cylinders > Molded Cylinders > Item # R10x12  
Download PDF Download PDF     Printable Page     Email Email This Page     Save To Favorites Save To Favorites

Item # R10x12, Molded PTFE Rod 10" x 12"



PTFE and Teflon Molded Rod

Fluoro-Plastics compression molds rods and cylinders for machining in a wide range of sizes. The most common sizes are listed in the table below, but many other combinations of OD and ID are available. Molded rods are preferred for machining because compression molding yields greater material homogeneity for the finished part.

Most rods are molded to 12 inches in length, although other lengths are available.

All rods can be etched for bonding.

All rods can be made with filled (reinforced) PTFE to enhance the performance parameters of PTFE. Materials available for reinforcement are Glass Fiber, Carbon, Graphite, Bronze, Molybdenum Disulfide, Polyimide, PPS and Stainless Steel.





 Specifications   

Specification Sheet

ASTM D 3294

Material Type

vir PTFE & Reinforced PTFE

OD

10.375 in

Length

12 in


 DOWNLOADS 

ASTM D 3294
(PDF, 4745KB)


 
Teflon is a registered trademark of Chemours LLC used under license by Fluoro-Plastics. Only Chemours makes Teflon.
 
Toll Free: 800-262-1910 • Local PA: 215-425-5500 • Fax: 215-425-5521• customerservice@Fluoro-Plastics.com
 
Copyright © Fluoro-Plastics • All Rights Reserved